How to maintain the led explosion proof light?
The installation and maintenance of LED explosion proof lights have the following points:
1. It is only necessary to open the outside of the casing and the buckle, and then open the lamp cover to connect the wires.
2. When introducing the sealing ring of the device, it is necessary to ensure its reliable pressurization and clamp the cable.
3. Use the blocking plate and the compression nut to reliably seal the unused inlet of the lamp, so that its explosion-proof and protection grade performance is guaranteed.
4. Before the lamp is put into use, it must be grounded inside and outside and the user grounding system should be connected.
5. When installing and maintaining the luminaire, remember not to turn it on.
6. Regularly check the sealing surface. If there is an aging phenomenon in the inspection, the lamp should be replaced in time.
7. The LED explosion proof lighting just released from the factory is almost in a state of being emptied, and it needs to be fully charged before use to be able to use normally.
Precautions when using LED explosion-proof lighting:
1. It is necessary to clean the dust and stains on the lamps from time to time. This can improve performance and light efficiency. How to clean better is to look at your lights, led explosion proof lights are best to use water spray method, but the premise is that you must cut the power supply, this can prevent the generation of static electricity.
2, to check if there is any damage, there is no trace of impact, if there is a problem, then do not use it, this is easy to go wrong, or to replace or repair.
3, there is to look at the problem of the light source, if there is damage, then have to quickly replace it. This will not have an abnormal state.
4, in the wet time is to be cleaned in time, to replace some parts, the protection of the outer casing should be ensured.
5, to open the lampshade must be cut off the power, but also to remind the warning card.
6, do not always open the place where the explosion-proof lamp is sealed, so it is easy to damage.
1. It is only necessary to open the outside of the casing and the buckle, and then open the lamp cover to connect the wires.
2. When introducing the sealing ring of the device, it is necessary to ensure its reliable pressurization and clamp the cable.
3. Use the blocking plate and the compression nut to reliably seal the unused inlet of the lamp, so that its explosion-proof and protection grade performance is guaranteed.
4. Before the lamp is put into use, it must be grounded inside and outside and the user grounding system should be connected.
5. When installing and maintaining the luminaire, remember not to turn it on.
6. Regularly check the sealing surface. If there is an aging phenomenon in the inspection, the lamp should be replaced in time.
7. The LED explosion proof lighting just released from the factory is almost in a state of being emptied, and it needs to be fully charged before use to be able to use normally.
Precautions when using LED explosion-proof lighting:
1. It is necessary to clean the dust and stains on the lamps from time to time. This can improve performance and light efficiency. How to clean better is to look at your lights, led explosion proof lights are best to use water spray method, but the premise is that you must cut the power supply, this can prevent the generation of static electricity.
2, to check if there is any damage, there is no trace of impact, if there is a problem, then do not use it, this is easy to go wrong, or to replace or repair.
3, there is to look at the problem of the light source, if there is damage, then have to quickly replace it. This will not have an abnormal state.
4, in the wet time is to be cleaned in time, to replace some parts, the protection of the outer casing should be ensured.
5, to open the lampshade must be cut off the power, but also to remind the warning card.
6, do not always open the place where the explosion-proof lamp is sealed, so it is easy to damage.
评论
发表评论